'Make us a component part of your business'

Home | About |
Contacts | FAQ
|
Products | Sitemap

OMEG E16 (ECO) BUSH HOUSING AND SPINDLE

This page provides the basic dimensions, bush and spindle information for the E16 (ECO) product range of Omeg potentiometers.

Basic dimensions

Bush Housing

Spindle options:

Cylindrical Spindles without a flat

Spindles with a flat ('D' section)

Spindles with a spline

Go to E16 (ECO) Potentiometer Data for the electrical and mechanical specifications; and

go to E16 (ECO) Potentiometer Types to select the unswitched model types available in this range.

E16 (ECO) BASIC DIMENSIONS

E16 (ECO) BUSH HOUSING

The E16 (ECO) bush housing is made of glass filled nylon, the thread is M10 x0.75mm pitch
and the bush is 8mm long.

Do not attempt to prevent any unwanted body rotation by overtightening the retaining nut, since this can cause thread damage, distortion, change of electrical resistance and restrict shaft rotation.
BS9130:1972 provides further details on this topic.
The recommended torque for tightening the retaining nut is 45cNm and this can be achieved cost effectively by using a Torque Limiting device as shown on our Accessories page.

E16 (ECO) SPINDLES

The E16 (ECO) plastic spindles are fixed and not removable.

They are available in length (L) from 14mm to 40mm maximum and in the following three diameters:

6.0mm Diameter

Cylindrical/NO Flat (Type F1)

4.0 x 12mm Flat (Type F2)

5.0 x 15mm Flat (Type F3)

5.0 x 10mm Flat (Type F4)

4.6mm x 15mm Flat (Type F11)

4.0 x 8mm Flat (Type F13)

5.0 x 8mm Flat (Type F14)

4.0mm Diameter

Cylindrical/NO Flat (Type F21)

3.0 x 8.5mm Flat (Type F22)

6.35mm Diameter

Cylindrical/NO Flat (Type F41)

5.5 x10mm Flat (Type F42)

Cylindrical and Flatted Spindles

Splined Spindle (6.0mm diameter)

A splined form is also available on the 6.0mm diameter E16 (ECO) plastic spindle.

Please note that this splined form is only available in a length (L) of 19mm.

This information is supplied in good faith but the customer is politely reminded that it is their responsibility to check the suitability of our products for their particular application. Please note that all dimensions are for reference purposes only and, as it is the Company's policy to continuously improve our products, we reserve the right to incorporate changes without notice.

CastelcoTM and OmegTM are
trademarks of Omeg Limited, Registered No. 600441,

Imberhorne Industrial Estate, East Grinstead, West Sussex RH19 1RJ Tel.+44(0)1342
410420